I have to get the HDMI cable, put it back in, start Windows, then put the DisplayPort cable in, switch to DisplayPort. So when I start the computer the next time with the DP cable on, the screen reports no signal and goes black again. And it worked.īUT: The problem is, that the effect does not persist. When I read it, I thought it was internet voodoo that would never work, but there were dozens of comments underneath that post thanking the guy. You really have to wait for quite some time. Based on 1,111,110 user benchmarks for the Nvidia GTX 1050-Ti and the GTX 970, we rank them both on effective speed and value for money against the best 639 GPUs. Note that just unplugging the power and immediately plugging it back in does not help at all. When you demand the absolute best graphic card available, look no further than the ZOTAC GeForce GTX 970 AMP Features Powered by GeForce GTX 970.
#Gtx 970 directcu mini no video output windows#
The following may sound really strange, but: I found a blog post (see here) that suggest to:Ġ) Connect both the HDMI and DP cables, then start Windows using HDMI modeġ) switch to display port using the OSD (will give no signal message, followed by sleep mode and black screen)Ģ) then remove the power cable from the monitor (switching the monitor off using the button will NOT do it)Īnd actually this works for me: the monitor comes back up with a signal from the display port and I can set higher Hz and activate gsync in the Nvidia control panel! I could not ignore this and read everything I could find on the internet. With the DP cable, the monitor does not work on the OSD only has one option: the input port (that can be switched between HDMI and DP).
Resolution in Windows: not applicable (Monitor does not work)įactory reset: Done via HDMI cable. AMD Phenom II X4 970 BE: Motherboard: ASUS M4A88TD-V EVO/USB3: Memory: Kingston HyperX DDR3 1600 4GB Kit: Hard Drive (internal) 250GB Western Digital SATA 3.0Gb/s 16MB cache: Video Cards: ASUS ENGTX460 DirectCU. Ports on the GFX card: 1x DP, 1x HDMI, 2x DVIĬonnection GFX card to Monitor: DisplayPort on the Gefore 970 connected directly via the original DP cable that came with the Dell Monitor to the DisplayPort on the Monitor Monitor purchased: 13 october 2017 from (So I can still return it) Here is the data which should be included in posts: If I can't get it to work soon, I'll have to return it, which would be a shame. I already tried the obvious (reboot, reset monitor to factory settings and then set the input to display part again, pull and check power cable, check display port cable on both ends).Īny suggestions on what more to try next?
(The monitor works when connected via HDMI, but it is a high-Hz Gsync monitor and both features are only available when connected via DisplayPort, so running it via HDMI is completely pointless.) And it requires only a single eight-pin power input. It’s fast, quiet, and an exceptional value for the money. To my Receiver (pass thru video to TV) the picture was fine, but it thought it was a DVI connection and wouldnt let me enable audio. When I switch to it, the monitor says "No signal" and then goes into sleep mode. The Asus Strix GTX 970 is among the finest video cards we’ve ever reviewed. On my newly purchased Dell S2417DG, the display port does not work.
0 kommentar(er)
